Sequence Testing Status			Ver 2.0 (MDM) 14-Mar-97

  Sequence Name				Status		Purpose						Uses
  -----------------			----------	-----------------------------------------	-------------
Baseline #1:
  DPM.ift_wlscan  			Run/NeedMod	Takes pictures through all wavelengths		* Test sequencer
  DPM.sqt_execlist 			Run/NeedMod	Fremlist and target list series			
  DPM.??				Not written	All camera modes				
  DPM.??				Not written	Several DHC extract modes			
  DPM.??				Not written	Time average test (4x4 binned)			
  DPM.sqt_timing			Available	Test sequence/CC timeout (watchdog, cmd count)

Baseline #2:
  CCK.logic1 				Un-Run		Sequencer test (registers and ExecteList exit)	
  CCK.logic2 				Un-Run		Sequencer test					
  CCK.logic3 				Un-Run		Sequencer test					
  CCK.logic4 				Un-Run		Sequencer test					
  CCK.logic5 				Un-Run		Sequencer test					

Baseline #3:
  DPM.speed64??				Not written	Take 64x64+ pictures as fast as possible
  DPM.speed1024??			Not written	Take 1024x1024 pictures as fast as possible	* Stress
  RAS.test.comp.short			Not written	JPEG/Pack/Lut Compression test (5-10 frames)				
  RAS.test.comp.long			Not written	JPEG/Pack/Lut Compression test (50-100 frames)				
  DPM.??				Not written	PZT test					
  TDT.test.focus			Not written	Focus series

Misc:
  TDT.test.4limb			Not written	North, South, East, West pointing		* ACS?
  TDT.test.fulldisk			Not written	Full disk mosaic				* ACS Mosaic
  emi_test??				OldRun		EMI/EMC testing					* EMI/EMC
  new_emi_test??			Re-write	EMI/EMC testing					* EMI/EMC

Upcoming Tests:
---------------
Mar 17-21	Finish TRACE "Functional Test" and debugging
			Run: DPM.ift_wlscan
Mar 24          Mosaic- Exercise the mosaic of the sun as part of the ACS dynamic simulation test.
			Run: TDT.test.fulldisk??
Mar 28          Initial acquisition test.  To be performed as part of the ACS phasing test.
Mar 28          Phasing-  Demostarte appropriate phasing of the diodes.
Mar 28          Latency- To verify the ACS to instrument system latency.
Apr  7          Stress test-  Instrument shall be on a mode where communications with the SCS are at its maximum.
			Run: DPM.speed1024??
Apr  8          28 Barker Code test- Instrument to perform 8 hours of science data and 20 hours of eclipse tests.
			Run: all sequences available(?)
Apr 10??	Operation simulation
			Run: all sequences available(?)
Notes:
------
  * Request 1-2 days of instrument test time before 7-Apr testing (in parallel with ACS testing?)
  * Levay to test "DPM.ift_wlscan" and "TDT.test.fulldisk??" at a minimum during the 17-Mar week
  * Extrace mode test will include a partial camera readout with DHC extract
  * "speed64" will do 64x64 raw, 64x64 JPEG, 64x128, 64x192, 64x256 to determine where the limitations come in.
  * "TDT.test.fulldisk??" does one frame per pointing position, 30 sec waits between
  * All sequences use UV open/open ("UVoo") wavelength when possible
  * All sequences don't command target when possible